Communication to the UPS has been lost. Steps to reestablish communication are in progress, The UPS has sensed a load greater than 100 percent of its rated capacity, The UPS failed its internal diagnostic self-test, The UPS just started a runtime calibration discharge. The UPS batteries are being discharged, The UPS has switched to battery backup power, The UPS has enabled Boost, The UPS batteries are low and will soon be exhausted. If utility power is not restored the UPS will put itself to 'sleep' and immediately cut power to the load, Communication with the UPS has been established, Utility power has been restored, The UPS passed its internal self-test, The UPS has returned from a low battery condition The UPS has been turned 'off' by the management station The UPS is entering 'sleep' mode. Power to the load will be cut off, The UPS woke up from 'sleep' mode. Power to the load has been restored, The UPS has started its reboot sequence. After the specified delay the UPS will perform a reboot, The environment temperature exceed the normal value, The environment temperature is normal, The environment humidity exceed the normal value, The environment humidity is normal, Smoke is abnormal, Water is abnormal, Security is abnormal, Water is normal